YASKAWA CIMR-ZU A Series Programming Manual page 48

1 2 b Application
b 8 b PI Setpoint User Display PI Setpoint Display Di its
When parameter b5-20 is set to 3, parameters b5-38 and b5-39 set a user-defined display for the PI setpoint (b5-19) and PI
feedback monitors (U5-01, U5-04).
Parameter b5-38 determines the display value when the maximum frequency is output and parameter b5-39 determines the
number of digits. The setting value is equal to the number of decimal places.
No
b5-38
b5-39
b Fre uency e erence Monitor Content Durin PI
Sets the content of the frequency reference monitor display (U1-01) when PI control is active.
No
b5-40 Frequency Reference Monitor Content During PI
Settin Fre uency e erence a ter PI
Monitor U1-01 displays the frequency reference increased or reduced for the PI output.
Settin 1 Fre uency e erence
Monitor U1-01 displays the frequency reference value.
b 1 PI Unit Selection
Sets the display units in U5-14 and U5-15.
No
b5-41
Settin C (Inc o
Settin 1 PSI (Pounds per S uare Inc )
Settin 2 GPM (Gallons per Minute)
Settin F (De rees Fa ren eit)
Settin CFM (Cubic Feet per Minute)
Settin CM (Cubic Meters per our)
Settin LP (Liters per our)
Settin 7 LPS (Liters per Second)
Settin 8 Bar (Bar)
Settin Pa (Pascal)
Settin 1 C (De rees Celsius)
Settin 11 Mtr (Meters)
Settin 12 Ft (Feet)
Settin 1 LPM (Liters per Minute)
Settin 1 CMM (Cubic Meters per Minute)
b 2 PI Output Monitor Calculation Met od
No
b5-42
Settin Linear
The monitor displays PI output.
Settin 1 S uare oot
The monitor displays square root PI output.
8
Name
PI Setpoint User Display
PI Setpoint Display Digits
Name
Name
PI Unit Selection
ater)
Name
PI Output Monitor Calculation Method
Settin an e
Determined by
1 to 60000
Determined by
0 to 3
Settin an e
0, 1
Settin an e
0 to 14
Settin an e
0 to 3
De ault
b5-20
b5-20
De ault
0
De ault
0
De ault
0