YASKAWA CIMR-ZU A Series Programming Manual page 157

1 7 Motor Base Speed
Sets the motor rated speed according to the motor nameplate value. Enter the speed at base frequency when using a motor
with an extended speed range or if using the motor in the field weakening area.
No
T1-07
1 11 Motor Iron Loss
Provides iron loss information to determine the Energy Saving coefficient. T1-11 will first display the value for the motor iron
loss that the drive automatically calculated when the motor capacity was entered to T1-02. Enter the motor iron loss value
listed to T1-11 if the motor test report is available.
No
T1-11
1 12 1 unin Start
Set T1-12 to 0 to start IM Auto-Tuning.
No
T1-12
2 Parameter Settin s durin PM Motor Auto unin
The T2- parameters are used to set the Auto-Tuning input data for PM motor tuning.
2 1 PM Motor Auto unin Mode Selection
No
T2-01
Settin PM Motor Parameter Settin s
2 PM Motor ype
Selects the type of PM motor the drive will operate.
No
T2-03
Settin IPM motor
Settin 1 SPM motor
2 PM Motor ated Po er
Specifies the motor rated power in kilowatts.
No
T2-04
2 PM Motor ated olta e
Sets the motor rated voltage.
No
T2-05
<1> Value shown is specific to 200 V class drives. Double value for 400 V class drives.
Name
Motor Base Speed
Name
Motor Iron Loss
Name
T1 Tuning Start
Name
PM Motor Auto-Tuning Mode Selection
Name
PM Motor Type
Name
PM Motor Rated Power
Name
PM Motor Rated Voltage
1 12
Settin an e
0 to 14400 r/min
Settin an e
0 to 65535 W
Settin an e
0
Settin an e
0
Settin an e
0, 1
Settin an e
Determined by o2-04
0.00 to 650.00 kW
Settin an e
0.0 to 255.0 V
<1>
Motor unin
De ault
1750 r/min
De ault
14 W
De ault
–
De ault
0
De ault
1
De ault
1
and C6-01
De ault
200.0 V
<1>
1 7