Bbacnet Setup Parameters; Bacnet Serial Communication - YASKAWA CIMR-ZU A Series Programming Manual

B BACnet Setup Parameters
B BACnet Setup Parameters

BACnet Serial Communication

This section describes parameters necessary to set up BACnet communications.
1 Dri e Sla e Address
Sets the drive slave address used for communications.
Cycle power for the setting to take effect.
Note:
No
H5-01
Each slave drive must be assigned a unique slave address for serial communications to work. Slave addresses do not need to
be assigned in sequential order, but no two drives may share the same address.
2 Communication Speed Selection
Sets the communications speed for APOGEE FLN, BACnet, MEMOBUS/Modbus, and Metasys N2.
1. Cycle power for the setting to take effect.
Note:
2. When Metasys N2 communications are selected (H5-08 = 1), selecting a baud rate other than 9600 bps will trigger an oPE29 error.
3. When APOGEE FLN (P1) communications are selected (H5-08 = 2), selecting a baud rate other than 4800 bps will trigger an oPE29
error.
4. When BACnet communications are selected (H5-08 = 3), selecting 115200 bps (Setting 8) will trigger an oPE29 error.
No
H5-02
<1> Default depends on H5-08 setting:
H5-08 = 0, MEMOBUS/Modbus; default: 3
H5-08 = 1, N2 (Metasys); default: 3
H5-08 = 2, P1 (APOGEE FLN); default: 2
H5-08 = 3, BACnet; default: 3
2
0
<1>
1
<1>
2
3
<1>
4
<1>
<1> Not available when H5-08 is set to 2 P1 (APOGEE FLN).
<2> Not available when H5-08 is set to 0 (MEMOBUS/Modbus) or 1 (Metasys N2).
Communication Parity Selection
Sets the parity used for communications.
Cycle power for the setting to take effect.
Note:
No
H5-03
Settin No parity
Settin 1 E en parity
Settin 2 Odd parity
Stoppin Met od a ter Communication Error
Selects the stopping method after a communications error (CE) has occurred.
288
Name
Drive Slave Address
Name
Communication Speed Selection
Communication Speed
1200 bps
2400 bps
4800 bps
9600 bps
19200 bps
Name
Communication Parity Selection
Settin an e
0 to FFH
Settin an e
0 to 8
2 Communication Speed
5
<1>
6
<1>
7
<1>
8
<1> <2>
Settin an e
0 to 2
De ault
1FH
De ault
<1>
38400 bps
57600 bps
76800 bps
115200 bps
De ault
0