YASKAWA CIMR-ZU A Series Programming Manual page 73

F 7 Net e /Com e Function Selection
Selects the treatment of multi-step speed inputs when the NetRef command is set.
No
F6-07
Settin Multi step Speed Operation Disabled
Multi-step speed input frequency references are disabled when the NetRef command is selected.
Settin 1 Multi step Speed Operation Enabled
Multi-step speed inputs are still active and can override the frequency reference from the communications option even when
the NetRef command is selected.
F 8 eset Communication Parameters
Determines whether F6-
No
F6-08
Settin Do Not eset F
Settin 1 eset F /F7
F6-08 is not reset when the drive is initialized.
Note:
F 1 bUS Error Auto eset
Selects whether a bUS error can be automatically reset if automatic fault retry is enabled.
No
F6-14
Settin Disabled Auto eset Not Possible
Settin 1 Enabled Auto eset Possible
F BACnet Baud ate
Sets the node address for a BACnet option card.
No
F6-46
Settin 12
Settin 1 2
Settin 2 8
Settin
Settin 1 2
Settin 8
Settin 7
Settin 7 7 8
Settin 8 11 2
F7 Communication Option Card
Parameters F7-01 to F7-42 are used for the Modbus TCP/IP and EtherNet/IP options.
Parameter Name
NetRef/ComRef Function Selection
/F7- communication-related parameters are reset after initialization.
Parameter Name
Reset Communication Parameters
/F7 Parameters a ter Initiali ation Usin A1
Parameters a ter Initiali ation Usin A1
Parameter Name
bUS Error Auto Reset
Parameter Name
BACnet Baud Rate
1 F Option Settin s
Settin an e
0, 1
Settin an e De ault
0, 1
Settin an e
0, 1
Settin an e
0 to 8
De ault
0
0
De ault
0
De ault
3
1
7