YASKAWA CIMR-ZU A Series Programming Manual page 141

S2 /S2 8/S2 1 /S2 18 Se uence imers 1 to
Sets the days for which sequence timers 1 to 4 are active.
No
S2-03
S2-08
S2-13
S2-18
Settin imer Disabled
Settin 1 Daily
Settin 2 Mon Fri
Settin Sat Sun
Settin Monday
Settin uesday
Settin ednesday
Settin 7 ursday
Settin 8 Friday
Settin Saturday
Settin 1 Sunday
S2 /S2 /S2 1 /S2 1
Sets the action that occurs when sequence timers 1 to 4 are active.
1. Setting 3 is available in drive software versions PRG: 8552 and later.
Note:
2. Setting 3 is not available in drive models 4A0930 and 4A1200.
No
S2-04
S2-09
S2-14
S2-19
Settin Di ital Output Only
Settin 1 un
Settin 2 un PI Disable
Settin Allo Alternation
When Sequence Selection is set to Allow Alternation and that timer is enabled (S2-03, S2-08, S2-13, S2-18 > 0), the drive
will only allow MEMOBUS alternation to occur during the time specified in the corresponding Sequence Timer. Alternation
is disabled when the timer deactivates.
S2 /S2 1 /S2 1 /S2 2
Selects the frequency reference source used for running the drive when sequence timers 1 to 4 are active (only applicable when
S2-04/S2-09/S2-14/S2-19 are set to 1 or 2).
H1- = 12/13 overrides these sequence timer run sources in drive software versions PRG: 1018 and later.
Note:
No
S2-05
S2-10
S2-15
S2-20
Name
Sequence Timer 1 Day Selection
Sequence Timer 2 Day Selection
Sequence Timer 3 Day Selection
Sequence Timer 4 Day Selection
Se uence imers 1/2/ / Selection
Name
Sequence Timer 1 Selection
Sequence Timer 2 Selection
Sequence Timer 3 Selection
Sequence Timer 4 Selection
Se uence imers 1/2/ /
Name
Sequence Timer 1 Reference Source
Sequence Timer 2 Reference Source
Sequence Timer 3 Reference Source
Sequence Timer 4 Reference Source
1 11 S Special Parameters
Day Selection
Settin an e
0 to 10
0 to 10
0 to 10
0 to 10
Settin an e
0 to 3
0 to 3
0 to 3
0 to 3
e erence Source
Settin an e
0 to 6
0 to 6
0 to 6
0 to 6
De ault
0
0
0
0
De ault
0
0
0
0
1
De ault
0
0
0
0
1 1