YASKAWA CIMR-ZU A Series Programming Manual page 92

1 7 erminal Functions
Settin 8 Dri e Enable
Reflects the status of a digital input configured as a "Drive enable" input (H1-
digital output set for "Drive enable" will also close.
Settin att our Pulse Output
Outputs a pulse to indicate the watt hours.
Settin A Dri e O er eat Alarm (o 2)
Output closes when the heatsink temperature exceeds the L8-02 Overheat Alarm Level.
Settin D Durin Speed Searc
The output terminal closes while Speed Search is being performed.
Settin E PID Feedbac Lo
The output terminal closes when a PID feedback loss is detected. The feedback is considered to be lost if it falls below the
level set to b5-13 for longer than the time set to b5-14.
Settin F PID Feedbac
The output terminal closes when a PID feedback loss is detected. The feedback is considered to be lost if it rises beyond the
level set to b5-36 for longer than the time set to b5-37.
Settin A Durin EB Operation
The output terminal closes while KEB is being performed.
Settin B Durin S ort Circuit Bra in
The output terminal closes while Short Circuit Braking is being executed.
Settin C Durin Fast Stop
The output terminal closes when a Fast Stop is being executed.
78.
Settin D o Pre Alarm ime Limit
The output terminal closes when the drive is reducing the speed due to a drive overheat alarm (L8-03 = 4) and the overheat
alarm has not disappeared after 10 frequency reduction operation cycles.
for a more detailed description.
Selection on page 119
Settin aitin to un ( rUn)
The drive will delay executing a Run command until the time set to b1-11 has expired.
Settin 1 Se uence imer 1 Acti e
Sequence Timer 1 is active.
2
OFF ON
run command
baseblock OFF
command
output
frequency
OFF ON
during run
OFF
during frequency
output
Fi ure 1 Durin Fre uency Output ime C art
i
ON
ON
Refer to b3: Speed Search on page 31
Refer to PI Feedback Loss Detection on page 42
Refer to PI Feedback Loss Detection on page 42
Refer to Settings 15 and 17: Fast Stop (N.O., N.C.) on page
Refer to L8-03: Overheat Pre-Alarm Operation
= 6A). If that digital input closes, then the
for details.
for details.
for details.