Table of Contents
Advertisement
Settin
2 Se uence imer 2 Acti e
Sequence Timer 2 is active.
Settin
Se uence imer
Sequence Timer 3 is active.
Settin
Se uence imer
Sequence Timer 4 is active.
Settin
8 Underload Detection
Underload is detected when the output current falls below the underload detection level defined by L6-14 and L6-02.
Settin
Internal Coolin Fan Alarm
The output closes when the drive internal cooling fan has failed.
Settin 71 Secondary PI Feedbac Lo
The PI2 feedback level is too low.
Settin 72 Secondary PI Feedbac
The PI2 feedback level is too high.
Settin A
BP Dri e elay
Line voltage is being supplied to the drive, and the motor is being run via the drive.
Available in V/f control mode.
Note:
Settin A
BP Bypass elay
Line voltage is being supplied directly to the motor.
Available in V/f control mode.
Note:
Settin A
BP BAS Interloc
Actuation signal for options dampers.
Available in V/f control mode.
Note:
Settin A
elay Operator Control
F1 (F2) key toggle relay is output.
Settin B2 BAS Interloc
A Run command is active or voltage is output. Actuation signal for damper.
Settin 1
to 1B2 Functions
These settings have the same function as settings 0 to B2, but with inverse output. Set as 1
output and the last two digits specify the setting number of the function.
Examples:
• Set 108 for inverse output of "8: During Baseblock (N.O.)".
• Set 14A for inverse output of "4A: During KEB Operation".
Acti e
Acti e
i
elay
elay Contact
to B2
it In erse Output
1 7
erminal Functions
, where the "1" indicates inverse
1
Advertisement
Table of Contents
