Subaru LEGACY 2006 Manual page 97

asieps_tobira.book 11 ページ ２００９年１０月２６日 月曜日 午前９時１６分
10.Fuel Tank Pressure Sensor
A: REMOVAL
1) Set the vehicle on a lift.
2) Open the fuel filler flap lid, and remove the fuel
filler cap.
3) Disconnect the ground cable from the battery.
4) Lift-up the vehicle.
5) Disconnect the connector from the fuel tank
pressure sensor.
6) Disconnect the pressure hose from the fuel tank
pressure sensor.
7) Remove the fuel tank pressure sensor along
with the bracket.
B: INSTALLATION
Install in the reverse order of removal.
Tightening torque:
7.4 N·m (0.75 kgf-m, 5.4 ft-lb)
C: INSPECTION
Make sure the hoses are not cracked or loose.
Fuel Tank Pressure Sensor
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)
IN-00203
EC-02084
EC-02084
EC(H4SO)-11