Subaru LEGACY 2006 Manual page 761

asieps_tobira.book 16 ページ ２００９年１０月２６日 月曜日 午前９時１６分
LUBRICATION
17) Remove the baffle plate.
(D)
(C)
(B)
(A)
(A) Oil pan
(B) Oil strainer
(C) Baffle plate
(D) Cylinder block
B: INSTALLATION
CAUTION:
Before installing the oil pan, clean the mating
surface of oil pan and engine block.
1) Make sure that the seals (A) are installed se-
curely on the buffle plate in a direction as shown in
the figure below. (Non-turbo model)
(A)
2) Install the baffle plate.
Tightening torque:
6.4 N·m (0.65 kgf-m, 4.7 ft-lb)
Oil Pan and Strainer
3) Install the oil strainer onto baffle plate.
NOTE:
Replace the O-ring with a new part.
Tightening torque:
10 N·m (1.0 kgf-m, 7.2 ft-lb)
4) Apply liquid gasket to the mating surfaces, and
install the oil pan.
Liquid gasket:
Three bond 1207C (Part No.004403012) or
equivalent
LU-02156
5) Tighten the bolt which installs oil pan to engine
block.
Tightening torque:
5 N·m (0.5 kgf-m, 3.6 ft-lb)
LU-00052
(A) Oil pan
(B) Oil strainer
(C) Baffle plate
(D) Cylinder block
6) Lower the engine onto front crossmember.
LU(H4SO)-16
LU-00034
(D)
(C)
(B)
(A)
LU-02156