Subaru LEGACY 2006 Manual page 896

asieps_tobira.book 19 ページ ２００９年１０月２６日 月曜日 午前９時１６分
9. SWITCH ASSEMBLY OPERATION
NOTE:
Test period of each test must be within short time (3
— 5 seconds).
1) Vacuum test
Disconnect the harness from terminal M and con-
nect it as shown in the figure. Make sure the pinion
gear sticks out.
(A)
(A) Terminal S
(B) Terminal M
2) Hold test
Make sure the pinion gear remains stick out even
after disconnecting terminal M in the above condi-
tion.
(A)
(A) Terminal S
(B) Terminal M
Starter
3) Return test
Connect the positive terminal to terminal S and the
negative terminal to terminal M and starter body to
pull the pinion gear at the main contact point. Make
sure the pinion gear returns to its original position
when the terminal S is disconnected.
(B)
SC-02086
10.PERFORMANCE TEST
The starter should be submitted to performance
tests whenever it has been overhauled, to assure
its satisfactory performance when installed on the
engine.
Three performance tests, no-load test, load test,
and lock test, are presented here; however, if the
load test and lock test cannot be performed, carry
out at least the no-load test.
(B)
For these performance tests, use the circuit shown
in figure.
SC-02087
SC(H4SO)-19
STARTING/CHARGING SYSTEMS
(B)
(A)
(A) Terminal S
(B) Terminal M
B
(B)
S
(A)
M
(C)
V A
(A) Variable resistance
(B) Starter body
(C) Magnetic switch
SC-02088
+
12V
SC-00077