Subaru LEGACY 2006 Manual page 847

asieps_tobira.book 73 ページ ２００９年１０月２６日 月曜日 午前９時１６分
28) Install the drive plate.
To lock the crankshaft, use the ST.
ST 498497100 CRANKSHAFT STOPPER
Tightening torque:
72 N·m (7.3 kgf-m, 52.8 ft-lb)
29) Install the housing cover.
30) Installation of oil pump:
(1) Discard the front oil seal after removal. Re-
place with a new part using ST.
ST 499587100 OIL SEAL INSTALLER
(2) Apply liquid gasket to the matching surface
of oil pump.
Liquid gasket:
Three bond 1215 (Part No. 004403007) or
equivalent
(A) O-ring
Cylinder Block
(3) Apply a coat of engine oil to the inside of oil
seal.
(4) Install the oil pump to cylinder block. Be
careful not to damage the oil seal during instal-
lation.
ME-00298
CAUTION:
• Make sure the oil seal lip is not folded.
• Do not forget to install the O-ring and seal
when installing oil pump.
(5) Apply liquid gasket to the three bolts thread
shown in figure.
Liquid gasket:
Three bond 1324 (Part No.004403042) or
equivalent
Tightening torque:
T: 6.4 N·m (0.65 kgf-m, 4.7 ft-lb)
ME-00164
(A)
ME-00165
ME(H4SO)-73
MECHANICAL
T
ME-00312
LU-02103