Subaru LEGACY 2006 Manual page 339

asieps_tobira.book 302 ページ ２００９年１０月２６日 月曜日 午前９時１６分
Diagnostic Procedure with Diagnostic Trouble Code (DTC)
ENGINE (DIAGNOSTICS)
Step
8 CHECK ACCELERATOR PEDAL POSITION
SENSOR.
1) Measure the resistance of accelerator
pedal position sensor.
Terminals
No. 3 — No. 5:
2) Check the measured value is within the
specification with the accelerator pedal
depressed.
Check
Is the resistance between 0.28
and 1.68 kΩ?
EN(H4SO)(diag)-302
Yes No
Repair the poor Replace the accel-
contact of ECM erator pedal posi-
connector. tion sensor.
Replace the ECM
if defective. <Ref.
to FU(H4SO)-36,
Engine Control
Module (ECM).>