Subaru LEGACY 2006 Manual page 911

asieps_tobira.book 6 ページ ２００９年１０月２６日 月曜日 午前９時１６分
ENGINE (DIAGNOSTICS)
12) Observe the following cautions when installing
a radio in MFI equipped models.
CAUTION:
• The antenna must be kept as far apart as pos-
sible from control unit. (The ECM is located un-
der the steering column, inside of the
instrument panel lower trim panel.)
• The antenna feeder must be placed as far
apart as possible from the ECM and MFI har-
ness.
• Carefully adjust the antenna for correct
matching.
• When mounting a large power type radio, pay
special attention to the three items mentioned
above.
• Incorrect installation of the radio may affect
the operation of ECM.
13) Before disconnecting the fuel hose, disconnect
the fuel pump connector and crank the engine for
five seconds or more to release pressure in the fuel
system. If engine starts during this operation, run it
until it stops.
14) Problems in the electronic-controlled automatic
transmission may be caused by failure of the en-
gine, the electronic control system, the transmis-
sion body, or by a combination of these. These
three (the engine, electronic control system and
transmission) causes must be distinguished clearly
when performing diagnostics.
15) Diagnostics should be conducted with simple,
easy operations first, and then with complicated,
difficult operations. The most important thing in di-
agnostics is to understand the customer's com-
plaint, and distinguish among the causes of engine,
electronic control system and transmission.
16) For AT models, do not hold the stall test for five
seconds or more at one time. (Fully open the throt-
tle from closed throttle to decrease engine speed.)
17) For the model with ABS, the ABS warning light
may illuminate when performing driving test with
jacked-up or lifted-up condition, but this is not a
system malfunction. The reason for this is the
speed difference between the front and rear
wheels. After diagnosis of engine control system,
perform the ABS memory clear procedure of self-
diagnosis function.
General Description
B: INSPECTION
Before performing diagnostics, check the following
item which might affect engine problems.
1. BATTERY
1) Measure the battery voltage and specific gravity
of electrolyte.
Standard voltage: 12 V
Specific gravity: Above 1.260
2) Check the condition of the main and other fuses,
and harnesses and connectors. Also check for
proper grounding.
2. ENGINE GROUND
Check if the engine ground terminal is properly
connected to engine.
EN(H4SO U5)(diag)-6
FU-01090