Subaru LEGACY 2006 Manual page 760

asieps_tobira.book 15 ページ ２００９年１０月２６日 月曜日 午前９時１６分
5. Oil Pan and Strainer
A: REMOVAL
1) Set the vehicle on a lift.
2) Remove the front wheels.
3) Disconnect the ground cable from battery.
4) Remove the air intake duct and air cleaner case.
<Ref. to IN(H4SO)-8, REMOVAL, Air Intake Duct.>
<Ref. to IN(H4SO)-5, REMOVAL, Air Cleaner
Case.>
5) Remove the air intake chamber.
<Ref. to IN(H4SO)-7, REMOVAL, Air Intake Cham-
ber.>
6) Remove the pitching stopper.
7) Remove the hood stay holder (A) and radiator
upper brackets (B).
(B)
Oil Pan and Strainer
IN-00203
ME-00213
(B)
(A)
LU-00232
LU(H4SO)-15
8) Support the engine with a lifting device and wire
ropes.
9) Lift-up the vehicle.
CAUTION:
When lifting up the vehicle, raise up wire ropes
at the same time.
10) Remove the under cover.
11) Drain the engine oil. <Ref. to LU(H4SO)-8, RE-
PLACEMENT, Engine Oil.>
12) Remove the front and center exhaust pipes.
<Ref. to EX(H4SO)-4, REMOVAL, Front Exhaust
Pipe.>
13) Remove the nuts which install front cushion
rubber onto front crossmember.
14) Remove the bolts which install oil pan on cylin-
der block with the engine raised up.
15) Insert the oil pan cutter blade into the gap be-
tween cylinder block and oil pan.
CAUTION:
Do not use a screwdriver or similar tool in place
of oil pan cutter.
16) Remove the oil strainer.
LUBRICATION
LU-00222
ME-02650