Subaru LEGACY 2006 Manual page 932

asieps_tobira.book 27 ページ ２００９年１０月２６日 月曜日 午前９時１６分
9. Subaru Select Monitor
A: OPERATION
1. HOW TO USE SUBARU SELECT MONI-
TOR
1) Prepare the Subaru Select Monitor kit. <Ref. to
EN(H4SO U5)(diag)-8, PREPARATION TOOL,
General Description.>
2) Connect the diagnosis cable to Subaru Select
Monitor.
3) Insert the cartridge to Subaru Select Monitor.
<Ref. to EN(H4SO U5)(diag)-8, PREPARATION
TOOL, General Description.>
4) Connect the Subaru Select Monitor to the data
link connector.
(1) Data link connector is located in the lower
portion of instrument panel (on the driver's
side).
Subaru Select Monitor
(2) Connect the diagnosis cable to data link
connector.
CAUTION:
Do not connect any scan tools except Subaru
Select Monitor or general scan tool.
5) Turn the ignition switch to ON (engine OFF) and
Subaru Select Monitor switch to ON.
EN-00038
(A) Power switch
6) Using the Subaru Select Monitor, call up DTCs
and data, then record them.
2. READ DIAGNOSTIC TROUBLE CODE
(DTC) FOR ENGINE (NORMAL MODE)
Refer to "Read Diagnostic Trouble Code" for infor-
mation about how to indicate DTC. <Ref. to
EN(H4SO U5)(diag)-35, Read Diagnostic Trouble
Code (DTC).>
3. READ DIAGNOSTIC TROUBLE CODE
(DTC) FOR ENGINE (OBD MODE)
Refer to "Read Diagnostic Trouble Code" for infor-
mation about how to indicate DTC. <Ref. to
EN(H4SO U5)(diag)-35, Read Diagnostic Trouble
EN-00039
Code (DTC).>
EN-02533
EN(H4SO U5)(diag)-27
ENGINE (DIAGNOSTICS)
(A)
EN-00040