Subaru LEGACY 2006 Manual page 846

asieps_tobira.book 72 ページ ２００９年１０月２６日 月曜日 午前９時１６分
MECHANICAL
21) Install the water pipe.
Tightening torque:
6.4 N·m (0.65 kgf-m, 4.7 ft-lb)
22) Install the baffle plate.
Tightening torque:
6.4 N·m (0.65 kgf-m, 4.7 ft-lb)
23) Install the oil strainer and O-ring.
Tightening torque:
9.75 N·m (1.0 kgf-m, 7.2 ft-lb)
24) Install the oil strainer stay.
25) Apply liquid gasket to the mating surfaces, and
install the oil pan.
Liquid gasket:
Three bond 1207C (Part No.004403012) or
equivalent
Cylinder Block
26) Apply liquid gasket to the mating surfaces and
the threaded portion of bolt (A) shown in the figure,
and then install the oil separator cover.
Liquid gasket:
• Mating surface
Three bond 1207C (Part No.004403012) or
equivalent
• (A) bolt threads
Three bond 1324 (Part No.004403042) or
equivalent
Tightening torque:
6.4 N·m (0.65 kgf-m, 4.7 ft-lb)
ME-00300
27) Install the flywheel. (MT model)
<Ref. to CL-13, INSTALLATION, Flywheel.>
To lock the crankshaft, use the ST.
ST 498497100
Tightening torque:
72 N·m (7.3 kgf-m, 52.8 ft-lb)
ME-00162
ME(H4SO)-72
(A)
ME-02452
CRANKSHAFT STOPPER
ST
ME-00297