Subaru LEGACY 2006 Manual page 813

bp06usen103.fm 55 ページ ２０１０年２月９日 火曜日 午後１時３５分
(11) Retighten bolts (a) and (b) by 40 — 45°.
CAUTION:
Make sure the total "tightening angle" of steps
(10) and (11) does not exceed 90°.
( a )
( c )
2) Install the camshaft. <Ref. to ME(H4SO)-51, IN-
STALLATION, Camshaft.>
3) Install the valve rocker assembly. <Ref. to
ME(H4SO)-48, INSTALLATION, Valve Rocker As-
sembly.>
4) Install the A/C compressor bracket on cylinder
head.
5) Install the intake manifold.
<Ref. to FU(H4SO)-13, INSTALLATION, Intake
Manifold.>
6) Install the cam sprocket. <Ref. to ME(H4SO)-45,
INSTALLATION, Cam Sprocket.>
7) Install the timing belt. <Ref. to ME(H4SO)-41,
INSTALLATION, Timing Belt.>
8) Install the timing belt cover.
<Ref. to ME(H4SO)-39, INSTALLATION, Timing
Belt Cover.>
9) Install the crank pulley. <Ref. to ME(H4SO)-38,
INSTALLATION, Crank Pulley.>
10) Install the V-belts. <Ref. to ME(H4SO)-36, IN-
STALLATION, V-belt.>
Cylinder Head
( f )
( d )
( b )
( e )
ME-02746
ME(H4SO)-55
C: DISASSEMBLY
1) Place the cylinder head on the ST.
ST 498267800 CYLINDER HEAD TABLE
2) Set the ST on valve spring. Compress the valve
spring and remove the valve spring retainer key.
Remove each valve and valve spring.
ST 499718000 VALVE SPRING REMOVER
NOTE:
• Keep all the removed parts in order for re-install-
ing in their original positions.
• Mark each valve to prevent confusion.
• Pay careful attention not to damage the lips of in-
take valve oil seals and exhaust valve oil seals.
ST
MECHANICAL
ME-00280