Subaru LEGACY 2006 Manual page 840

asieps_tobira.book 66 ページ ２００９年１０月２６日 月曜日 午前９時１６分
MECHANICAL
B: INSTALLATION
(1)
(1) Crankshaft bearing
(2) Crankshaft
NOTE:
Remove oil on the mating surface of bearing and
cylinder block before installation. Apply engine oil
to crankshaft pins.
1) Position the crankshaft and O-rings on the #1
and #3 cylinder block.
2) Apply liquid gasket to the mating surface of #1
and #3 cylinder block, and position #2 and #4 cylin-
der block.
Liquid gasket:
Three bond 1215 (Part No. 004403007) or
equivalent
Cylinder Block
(5)
(4)
(2)
(3)
(3) Cylinder block
(4) Rear oil seal
NOTE:
Do not allow liquid gasket to jut into O-ring grooves,
oil passages, bearing grooves, etc.
3) Apply a coat of engine oil to the washer and bolt
thread.
ME(H4SO)-66
(3)
ME-02923
(5) O-ring
ME-00145