Subaru LEGACY 2006 Manual page 49

asieps_tobira.book 11 ページ ２００９年１０月２６日 月曜日 午前９時１６分
6) Press the "UNLOCK" button momentarily on the
keyless transmitter. Check that the driver's door is
unlocked and hazard light blinks twice and the
buzzer sounds twice.
And press the "UNLOCK" button momentarily
again in 5 seconds. Check that all the doors includ-
ing rear gate are unlocked.
7) Within a distance of 10 m (33 ft) from a vehicle,
press keyless transmitter's "LOCK" button three
times within 5 seconds. Check that the horn honks
once and that the hazard light blinks three times.
8) Move the power door lock switch to the lock po-
sition with one of doors (including the rear gate)
opened. Next, close all the doors including rear
gate. Check if all the doors are locked and buzzer
sounds once and the hazard light flashes once.
9) Check buzzer operation
The buzzer rings when the doors are locked or un-
locked. The buzzer can be turned off if desired.
Turn the buzzer off or on with following procedure.
(1) Close all the doors including rear gate, then
remove the key from ignition key lock.
(2) Press the power door lock switch to unlock
and hold it until the operation is finished.
(3) Insert the key into ignition key lock, and in-
sert and remove the key in ignition key lock 5
times in 10 seconds.
(4) When finished step (3), open and close the
driver's door once within 10 seconds.
NOTE:
When opening and closing of the door is not avail-
able within 10 seconds, hazard light blinks once
and the change over operation is cancelled. Retry
from the step (1).
(5) Hazard light blinks 3 times and the buzzer
sound turns ON or OFF.
Pre-delivery Inspection
10) Press the "Panic" button on the backside of the
keyless transmitter. Check if the alarm condition
happens (horn sounds continuously, hazard light
blinks, security indicator comes on). Check wheth-
er this condition lasts until any button on the key-
less transmitter is pressed or lasts for 30 seconds.
PI-00256
23.ALARM SYSTEM
NOTE:
The following inspections show the initial settings.
When the settings are different from the initial set-
tings, use Subaru Select Monitor to check the de-
tails of each setting for inspections. <Ref. to
LAN(diag)-28, OPERATION, Function Setting
(Customize).>
1) Fully open all the door windows.
2) Remove the key from the ignition switch and
close all the doors including rear gate.
3) Press the "LOCK" button momentarily on the
keyless transmitter. All doors are locked, and buzz-
er sound once, hazard blinks once, security indica-
tor light blinks fast (five times per two seconds) for
30 seconds and goes slower (twice per two sec-
onds), then the alarm system is in set condition.
PI-11
PRE-DELIVERY INSPECTION
PI-00257
PI-00255