Subaru LEGACY 2006 Manual page 832

asieps_tobira.book 83 ページ ２００９年１０月２６日 月曜日 午前９時１６分
22.Oil Switching Solenoid Valve
A: REMOVAL
1. RH SIDE
1) Disconnect the ground cable from the battery.
2) Remove the air intake chamber.
<Ref. to IN(H4SO)-7, REMOVAL, Air Intake Cham-
ber.>
3) Remove the engine harness connector from the
bracket.
4) Disconnect the connector from the oil switching
solenoid valve.
5) Remove the oil switching solenoid valve.
6) Remove the variable valve lift diagnosis oil pres-
sure switch.
<Ref. to FU(H4SO)-30, REMOVAL, Variable Valve
Lift Diagnosis Oil Pressure Switch.>
7) Remove the oil temperature sensor.
<Ref. to FU(H4SO)-31, REMOVAL, Oil Tempera-
ture Sensor.>
Oil Switching Solenoid Valve
8) Remove the oil switching solenoid valve holder
from the cylinder head.
FU-00009
2. LH SIDE
1) Disconnect the ground cable from the battery.
ME-02697
2) Remove the V-belts.
<Ref. to ME(H4SO)-36, REMOVAL, V-belt.>
3) Remove the crank pulley.
<Ref. to ME(H4SO)-38, REMOVAL, Crank Pul-
ley.>
4) Remove the timing belt cover.
<Ref. to ME(H4SO)-39, REMOVAL, Timing Belt
Cover.>
5) Remove the timing belt.
<Ref. to ME(H4SO)-40, REMOVAL, Timing Belt.>
6) Remove the cam sprocket.
<Ref. to ME(H4SO)-45, REMOVAL, Cam Sprock-
et.>
7) Remove the timing belt cover No. 2 (LH).
8) Disconnect the connector from the oil switching
solenoid valve.
9) Remove the oil switching solenoid valve.
10) Remove the variable valve lift diagnosis oil
pressure switch.
<Ref. to FU(H4SO)-30, REMOVAL, Variable Valve
Lift Diagnosis Oil Pressure Switch.>
ME(H4SO)-83
(A) (C)
(B)
(D)
(E)
(A) Oil switching solenoid valve
(B) Variable valve lift diagnosis oil pressure switch
(C) Oil temperature sensor
(D) Oil switching solenoid valve holder
(E) Gasket
MECHANICAL
ME-02726
FU-00009