Subaru LEGACY 2006 Manual page 890

asieps_tobira.book 13 ページ ２００９年１０月２６日 月曜日 午前９時１６分
12) Assemble the brush assembly to end frame.
NOTE:
• Be careful not to allow grease to get on brush.
• Align the rubber seal part with end frame groove.
Tightening torque:
1.4 N·m (0.14 kgf-m, 1.03 ft-lb)
13) Install the armature to end frame.
NOTE:
• Apply grease to the rear bearing inner circumfer-
ence.
• Be careful not to allow grease to attach to com-
mutator.
Grease:
DENSO HL50
Starter
14) Set the space ring, then assemble the snap
ring.
NOTE:
• Use new snap rings.
• Check the dimension of (A) in the figure after as-
sembling snap ring. If it exceeds 5.0 mm (0.20 in),
assemble a new snap ring again.
SC-02048
SC-02047
15) Install the end frame cover.
(A) End frame cover
SC(H4SO)-13
STARTING/CHARGING SYSTEMS
SC-02045
(A)
SC-02069
(A)
SC-02044