Subaru LEGACY 2006 Manual page 883

asieps_tobira.book 6 ページ ２００９年１０月２６日 月曜日 午前９時１６分
STARTING/CHARGING SYSTEMS
2. Starter
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the air intake chamber. (Non-turbo
model) <Ref. to IN(H4SO)-7, REMOVAL, Air Intake
Chamber.> <Ref. to IN(H6DO)-7, REMOVAL, Air
Intake Chamber.>
3) Remove the intercooler. (Turbo model)
<Ref. to IN(H4DOTC)-12, REMOVAL, Intercool-
er.>
4) Remove the air intake chamber stay LH. (2.5 L
Non-turbo model)
5) Disconnect the connector and terminal from
starter.
(B)
(A) Terminal
(B) Connector
6) Remove the starter from transmission.
B: INSTALLATION
Install in the reverse order of removal.
Tightening torque:
50 N·m (5.1 kgf-m, 37 ft-lb)
Starter
C: DISASSEMBLY
1. STARTER ASSEMBLY
1) Loosen the nut which holds terminal M of mag-
net switch assembly, and then disconnect the har-
ness from terminal.
IN-00203
2) Remove the bolts which hold switch assembly,
and then remove the switch assembly, plunger and
plunger spring from starter.
(A)
3) Remove the nuts of both sides, and then remove
the rear cover.
SC-02038
SC(H4SO)-6
(A) Terminal M
(A)
SC-02039
SC-02040
SC-02041