Subaru LEGACY 2006 Manual page 15

asieps_tobira.book 10 ページ ２００９年１０月２６日 月曜日 午前９時１６分
NOTE
11.GENERAL SCAN TOOL
Using general scan tools will greatly improve the ef-
ficiency of repairing engine electronic controls.
Subaru Select Monitor can be used to diagnose the
engine, ABS, air conditioner and other parts.
12.AWD CIRCUIT MEASURES
1) Full-time AWD MT model
Since viscous coupling (limited slip differential) is
used in the center differential, cut-off of AWD circuit
cannot be carried out.
2) Full-time AWD 5AT model
Since VTD type is used in the center differential,
cut-off of AWD circuit cannot be carried out.
3) Full-time AWD 4AT model
Insert a spare fuse into FWD fuse holder in the fuse
box located in the left side of engine room to select
the FWD. Since electronically controlled MT-P hy-
draulic multi-plate clutch is adapted for center dif-
ferential, select FWD. When maintenance is
performed with jack-up or on the free roller, check
the illumination of AWD warning light in the combi-
nation meter.
(A)
(B)
(A) FWD fuse holder
(B) AWD warning light
13.SPEEDOMETER TEST
1) Rear wheel free roller system
(1) Set the free roller on the floor of rear wheel
side securely according to the wheel base and
rear tread of the vehicle.
Note
(2) Let the vehicle ride on the tester and free
roller gently.
CAUTION:
Fix the vehicle using a pulling metal (chain or
wire) to the front and rear towing hooks or tie-
down hook to prevent the lateral runout of front
wheels and springing out of vehicle.
(A) Free roller
(3) Set the speedometer tester.
(4) Conduct the speedometer test work.
CAUTION:
Do not operate the clutch quickly and do not ac-
celerate or decelerate suddenly during work.
2) Rear wheel jack-up system
(1) Set the vehicle on speedometer tester.
CAUTION:
Fix the vehicle using a pulling metal (chain or
wire) to the front and rear towing hooks or tie-
down hook to prevent the lateral runout of front
wheels and springing out of vehicle.
(2) Jack up the rear wheels and set the rigid
racks to the specified locations of side sill.
NT-00081
(A) Rigid rack
(3) Conduct the speedometer test work.
CAUTION:
Do not operate the clutch quickly and do not ac-
celerate or decelerate suddenly during work.
NT-10
(A)
NT-00033
(A)
NT-00034