Subaru LEGACY 2006 Manual page 951

asieps_tobira.book 46 ページ ２００９年１０月２６日 月曜日 午前９時１６分
ENGINE (DIAGNOSTICS)
13.Clear Memory Mode
A: OPERATION
1. SUBARU SELECT MONITOR (NORMAL
MODE)
1) On the «Main Menu» display screen, select the
{Each System Check} and press the [YES] key.
2) On the «System Selection Menu» display
screen, select the {Engine Control System} and
press the [YES] key.
3) Press the [YES] key after the information of en-
gine type has been displayed.
4) On the «Engine Diagnosis» display screen, se-
lect the {Clear Memory} and press the [YES] key.
5) When the "Done" and "Turn Ignition Switch OFF"
are shown on the display screen, turn the ignition
switch to OFF and then Subaru Select Monitor
switch to OFF.
NOTE:
• Initial diagnosis of electronic throttle control is
performed after memory clearance. For this rea-
son, start the engine after 10 seconds or more have
elapsed since the ignition switch was turned to ON.
• For detailed operation procedure, refer to the
"SUBARU SELECT
MANUAL".
2. SUBARU SELECT MONITOR (OBD
MODE)
1) On the «Main Menu» display screen, select the
{Each System Check} and press the [YES] key.
2) On the «System Selection Menu» display
screen, select the {Engine Control System} and
press the [YES] key.
3) Press the [YES] key after the information of en-
gine type has been displayed.
4) On the «Engine Diagnosis» display screen, se-
lect the {OBD System} and press the [YES] key.
5) On the «OBD Menu» display screen, select
{DTC Clear} and press the [YES] key.
6) When the "Clear Diagnostic Code?" is shown on
the screen, press the [YES] key.
7) Turn the ignition switch to OFF and then turn the
Subaru Select Monitor switch to OFF.
NOTE:
• Initial diagnosis of electronic throttle control is
performed after memory clearance. For this rea-
son, start the engine after 10 seconds or more have
elapsed since the ignition switch was turned to ON.
• For detailed operation procedure, refer to the
"SUBARU SELECT
MANUAL".
Clear Memory Mode
MONITOR OPERATION
MONITOR OPERATION
EN(H4SO U5)(diag)-46
3. GENERAL SCAN TOOL
For clear memory procedures using the general
scan tool, refer to "General Scan Tool Instruction
Manual".
NOTE:
Initial diagnosis of electronic throttle control is per-
formed after memory clearance. For this reason,
start the engine after 10 seconds or more have
elapsed since the ignition switch was turned to ON.