Subaru LEGACY 2006 Manual page 53

asieps_tobira.book 15 ページ ２００９年１０月２６日 月曜日 午前９時１６分
49.ATF LEVEL
After selecting all positions (P, R, N, D), set the se-
lect lever in "P" range. Idle the engine for 1-2 min-
utes, and measure the ATF level. If the amount is
insufficient, check that no leaks are found. Then,
add the necessary amount of the specified ATF.
• 4AT
(A)
(A) Level gauge
(B) ATF level range at "HOT" [70 — 80°C (158 —
176°F)]
(C) Upper level
(D) Lower level
(E) ATF level range at "COLD" [20 — 30°C (68 —
86°F)]
• 5AT
(A)
(A) Level gauge
(B) ATF level range at "HOT" [70 — 80°C (158 —
176°F)]
(C) Upper level
(D) Lower level
(E) ATF level range at "COLD" [20 — 30°C (68 —
86°F)]
Pre-delivery Inspection
50.POWER STEERING FLUID LEVEL
Check that the power steering fluid level is normal.
If the amount is insufficient, check that no leaks are
found. Then add the necessary amount of the
specified power steering fluid.
(C)
(B)
(D)
(C)
(E)
(D)
51.FLUID LEAK CHECK
PI-00189
Check entire areas of the vehicle for any trace of
coolant/oil/fluid leaks.
52.WATER LEAK TEST
Spray the vehicle with water using a hose and
check that no water enters the passenger compart-
ment.
• Before performing the water leakage test, re-
move anything that may obstruct the operation or
which must be kept dry.
• Close all the windows and doors securely. Close
the hood and trunk lid before starting the test.
(A)
• Spray the vehicle with water using a hose. The
rate of water spray must be approx. 20 — 25 2 (5.3
(C)
(B)
— 6.6 US gal, 4.4 — 5.5 Imp gal) per minute.
(D)
When spraying water on areas adjacent to the floor
and wheel house, increase the pressure. When
(C)
spraying water on areas other than the floor and
(E)
wheel house, decrease the pressure. But the force
(D)
of water must be made strong occasionally by
pressing the end of the hose.
PI-00190
NOTE:
Be sure to keep the hose at least 10 cm (3.9 in)
away from vehicle.
Check the following areas.
• Front window and body framework mating por-
tion
• Door mating portions
• Glass mating portions
• Rear quarter window mating portions
• Rear window and body framework mating portion
• Around roof drips
If any dampness in the compartments is discovered
after the water has been applied, carefully check all
the areas that may have possibly contributed to the
leak.
PI-15
PRE-DELIVERY INSPECTION
HOT MAX
COLD MAX
HOT MIN
COLD MIN
PS-00463