Subaru LEGACY 2006 Manual page 844

asieps_tobira.book 70 ページ ２００９年１０月２６日 月曜日 午前９時１６分
MECHANICAL
19) Install the piston.
(1) Place the cylinder block to face the #1 and
#2 cylinder side upward.
(2) Using the ST1, turn the crankshaft so that #1
and #2 connecting rods are set at bottom dead
center.
ST1 499987500 CRANKSHAFT SOCKET
(3) Apply a coat of engine oil to the pistons and
cylinders and insert pistons in their cylinders us-
ing ST2.
ST2 498747300 PISTON GUIDE
ST2
20) Install the piston pin.
(1) Apply a coat of engine oil to ST3.
(2) Insert ST3 into the service hole to align pis-
ton pin hole with connecting rod small end.
ST3 499017100 PISTON PIN GUIDE
ST1
(3) Apply a coat of engine oil to piston pin, and
insert the piston pin into piston and connecting
rod through service hole.
(4) Install the snap ring.
NOTE:
Use new snap rings.
Cylinder Block
ST1
ME-00157
ST3
ME-00158
ME-00159
ME(H4SO)-70
(5) Apply liquid gasket around the service hole
plug.
Liquid gasket:
Three bond 1105 (Part No. 004403010) or
equivalent
ME-00160