Subaru LEGACY 2006 Manual page 897

asieps_tobira.book 20 ページ ２００９年１０月２６日 月曜日 午前９時１６分
STARTING/CHARGING SYSTEMS
1) No-load test
With switch on, adjust the variable resistance until
the voltage is 11 V, read the value of ammeter to
measure rotating speed. Compare these values
with the standard.
No-load test (Standard):
Voltage/Current
MT model
Max. 11 V/90 A or less
AT model
Max. 11 V/90 A or less
Rotating speed
MT model
1,820 rpm or more
AT model
1,720 rpm or more
2) Load test
Apply the specified braking torque to starter. The
condition is satisfactory if the current draw and ro-
tating speed are within specifications.
Load test (Standard):
Voltage/Load
MT model
8 V/7.76 N·m (0.79 kgf-m, 5.7 ft-lb)
AT model
8 V/12.78 N·m (1.30 kgf-m, 9.4 ft-lb)
Current/Speed
MT model
280 A/900 rpm or more
AT model
370 A/850 rpm or more
3) Lock test
With the starter stalled, or not rotating, measure the
torque developed and current draw when the volt-
age is adjusted to standard voltage.
Lock test (Standard):
Voltage/Current
MT model
3 V/900 A or less
AT model
3 V/900 A or less
Torque
MT model
13.62 N·m (1.38 kgf-m, 10.0 ft-lb)
AT model
15.42 N·m (1.57 kgf-m, 11.3 ft-lb)
Starter
SC(H4SO)-20