Subaru LEGACY 2006 Manual page 929

asieps_tobira.book 24 ページ ２００９年１０月２６日 月曜日 午前９時１６分
ENGINE (DIAGNOSTICS)
8. General Scan Tool
A: OPERATION
1. HOW TO USE GENERAL SCAN TOOL
1) Prepare a scan tool (general scan tool) required
by SAE J1978.
2) Open the cover and connect the general scan
tool to the data link connector located in the lower
portion of instrument panel (on the driver's side).
3) Using the general scan tool, call up DTC and
freeze frame data.
General scan tool functions consist of:
(1) MODE $01: Current powertrain diagnostic
data
(2) MODE $02: Powertrain freeze frame data
(3) MODE $03: Emission-related powertrain
DTC
(4) MODE $04: Clear/Reset emission-related
diagnostic information
(5) MODE $06: Request on-board monitoring
test results for non-continuously monitored sys-
tems
(6) MODE $07: Request on-board monitoring
test results for continuously monitored systems
(7) MODE $09: Request vehicle information
Read out the data according to repair procedures.
(For detailed operation procedure, refer to the gen-
eral scan tool instruction manual.)
NOTE:
For details concerning DTC, refer to "List of Diag-
nostic Trouble Code (DTC)". <Ref. to EN(H4SO
U5)(diag)-73, List of Diagnostic Trouble Code
(DTC).>
General Scan Tool
EN-02533
EN(H4SO U5)(diag)-24