Subaru LEGACY 2006 Manual page 857

asieps_tobira.book 50 ページ ２００９年１０月２６日 月曜日 午前９時１６分
MECHANICAL
19.Camshaft
A: REMOVAL
1) Remove the V-belts. <Ref. to ME(H4SO)-36,
REMOVAL, V-belt.>
2) Remove the crank pulley. <Ref. to ME(H4SO)-
38, REMOVAL, Crank Pulley.>
3) Remove the timing belt cover. <Ref. to
ME(H4SO)-39, REMOVAL, Timing Belt Cover.>
4) Remove the timing belt. <Ref. to ME(H4SO)-40,
REMOVAL, Timing Belt.>
5) Remove the cam sprocket. <Ref. to ME(H4SO)-
45, REMOVAL, Cam Sprocket.>
6) Remove the timing belt cover No. 2 (LH).
7) Remove the timing belt cover No. 2 (RH).
NOTE:
Do not damage or lose the seal rubber when re-
moving the timing belt covers.
8) Remove the tensioner bracket.
9) Remove the camshaft position sensor support.
(LH side only)
10) Remove the oil level gauge guide. (LH side
only)
11) Remove the valve rocker assembly. <Ref. to
ME(H4SO)-47, REMOVAL, Valve Rocker Assem-
bly.>
Camshaft
12) Remove the camshaft cap.
(1) Remove the bolts (a) and (b) in alphabetical
sequence.
(a)
(b)
(2) Equally loosen the bolts (c) through (j) all the
way in alphabetical sequence.
(d)
(c)
(3) Remove the bolts (k) through (p) in alpha-
betical sequence using ST.
ME-00258
ST 499497000
(k)
ME-00259
(4) Remove the camshaft cap.
13) Remove the camshaft.
14) Remove the oil seal.
15) Remove the plug from rear side of camshaft.
CAUTION:
• Do not remove the oil seal unless necessary.
• Do not scratch the journal surface when re-
moving the oil seal.
ME(H4SO)-50
ME-02707
(j)
(h)
(g)
(i)
ME-02708
®
TORX PLUS
(n) (p)
(o)
ME-02709
(f)
(e)
(l)
(m)