Subaru LEGACY 2006 Manual page 892

asieps_tobira.book 15 ページ ２００９年１０月２６日 月曜日 午前９時１６分
20) Install the rear cover.
21) Install the magnet switch assembly to front
bracket.
(1) Assemble the plunger hook to lever.
NOTE:
Apply grease to the plunger hook and sleeve inner
circumference.
Grease:
DENSO HL50
(A)
(B)
(A) Lever
(B) Plunger hook
(2) Assemble the plunger spring and magnet
switch to front bracket.
NOTE:
Apply grease to the end surface of magnet switch
as shown in the figure.
Grease:
DENSO HL50
(A)
(A) 5 mm
Starter
SC-02041
(A) Plunger
(B) Plunger spring
(C) Magnet switch
(3) Tighten the bolt.
Tightening torque:
7.5 N·m (0.8 kgf-m, 5.5 ft-lb)
22) Connect the harness to terminal M of magnet
SC-02074
switch assembly.
Tightening torque:
10 N·m (1.0 kgf-m, 7.4 ft-lb)
(A) Terminal M
SC-02075
SC(H4SO)-15
STARTING/CHARGING SYSTEMS
(C)
(A) (B)
SC-02076
SC-02040
(A)
SC-02039