Subaru LEGACY 2006 Manual page 696

asieps_tobira.book 48 ページ ２００９年１０月２６日 月曜日 午前９時１６分
FUEL INJECTION (FUEL SYSTEMS)
B: INSTALLATION
1) Open the fuel filler flap lid.
2) Set the fuel saucer (A) with rubber packing (C),
and insert the fuel filler pipe into hole from the inner
side of apron.
3) Align the holes in fuel filler pipe neck and set the
cup (B), and tighten the screws.
NOTE:
If the edges of rubber packing are folded toward in-
side, straighten it with a flat tip screwdriver.
4) Securely insert the fuel filler hose (A) and Evap-
oration hose (B) to the specified position, then tight-
en the clamp.
Tightening torque:
2.5 N·m (0.3 kgf-m, 1.8 ft-lb)
(A)
Fuel Filler Pipe
(A)
5) Tighten the bolts which hold fuel filler pipe brack-
(B) et on the body.
Tightening torque:
(C)
FU-00103
6) Install the rear sub frame. <Ref. to RS-21, IN-
STALLATION, Rear Sub Frame.>
(B)
7) Install the mud guard. <Ref. to EI-29, INSTAL-
LATION, Mud Guard.>
8) Install the rear wheel RH.
FU-02396
(B)
9) Lower the vehicle.
FU-02397
FU(H4SO)-48
( 1 )
(1) Hose
(2) Clip or clamp
(3) Pipe
7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
( 2 ) ( 3 )
L/2
L
FU-00104
FU-02395
FU-00096