Subaru LEGACY 2006 Manual page 803

asieps_tobira.book 31 ページ ２００９年１０月２６日 月曜日 午前９時１６分
26) Remove the engine from vehicle.
(1) Slightly raise the engine.
(2) Raise the transmission with garage jack.
(3) Move the engine horizontally until main shaft
is withdrawn from clutch cover.
(4) Slowly move the engine away from engine
compartment.
NOTE:
Be careful not to damage adjacent parts or body
panels with crank pulley, oil level gauge, etc.
27) Remove the front cushion rubbers.
B: INSTALLATION
1) Install the front cushion rubbers to engine.
Tightening torque:
35 N·m (3.6 kgf-m, 25.8 ft-lb)
2) Position the engine in engine compartment and
align it with transmission.
NOTE:
Be careful not to damage adjacent parts or body
panels with crank pulley, oil level gauge, etc.
3) Apply a small amount of grease to splines of
mainshaft. (MT model)
4) Tighten the bolts which hold upper side of trans-
mission to engine.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
5) Remove the lifting device and wire ropes.
6) Remove the garage jack.
Engine Assembly
7) Attach the pitching stopper.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 36.9 ft-lb)
T2: 58 N·m (5.9 kgf-m, 42.8 ft-lb)
8) Remove the ST from converter case. (AT model)
NOTE:
Be careful not to drop the ST into the converter
case when removing the ST.
ST 498277200
9) Install the starter. <Ref. to SC(H4SO)-6, IN-
STALLATION, Starter.>
10) Install the torque converter clutch to drive plate.
(AT model)
(1) Tighten the bolts which hold torque convert-
er clutch to drive plate.
(2) Tighten other bolts while rotating the crank-
shaft using socket wrench.
CAUTION:
Be careful not to drop bolts into the torque con-
verter clutch housing.
LU-00222
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
(3) Attach the service hole plug to prevent entry
of foreign objects.
ME-00216
ME(H4SO)-31
MECHANICAL
T2 T1
ME-00218
STOPPER SET
ME-00212