Subaru LEGACY 2006 Manual page 69

asieps_tobira.book 23 ページ ２００９年１０月２６日 月曜日 午前９時１６分
8. Radiator Main Fan and Fan
Motor
A: REMOVAL
1) Set the vehicle on a lift.
2) Disconnect the ground cable from battery.
3) Lift-up the vehicle.
4) Remove the under cover.
5) Remove the radiator under cover.
6) Disconnect the connector (A) of the main fan
motor.
(A)
7) Remove the ATF hose from the clip of the radia-
tor main fan motor assembly. (AT model)
8) Lower the vehicle.
9) Disconnect the over flow hose.
10) Remove the reservoir
CO(H4SO)-27, REMOVAL, Reservoir Tank.>
11) Remove the bolts which hold the radiator main
fan shroud to the radiator.
12) Remove the radiator main fan motor assembly.
Radiator Main Fan and Fan Motor
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
If the installation of the radiator main fan motor as-
sembly is difficult, attempt installation after loosen-
ing the bolts which hold the radiator sub fan motor
assembly.
Tightening torque:
IN-00203
C: DISASSEMBLY
1) Remove the clip which holds motor connector
onto the shroud.
2) Remove the nut which holds the fan to the fan
motor and shroud.
CO-02097
3) Remove the bolts which hold fan motor onto
tank. <Ref. to
shroud.
CO-00096
CO(H4SO)-23
7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
COOLING
CO-00096
CO-00102
CO-00098