Subaru LEGACY 2006 Manual page 693

asieps_tobira.book 9 ページ ２００９年１０月２６日 月曜日 午前９時１６分
(1) Clamp
(2) Fuel damper valve
(3) Evaporation hose A
(4) Clip
(5) Fuel delivery hose A
(6) Fuel delivery hose B
(7) Fuel damper valve bracket
(8) Fuel pipe ASSY
(9) Fuel delivery hose C
(10) Evaporation hose B
(11) Clamp
(12) Grommet
(13) Fuel pipe ASSY
C: CAUTION
• Wear appropriate work clothing, including a cap, protective goggles and protective shoes when performing
any work.
• Remove contamination including dirt and corrosion before removal, installation or disassembly.
• Keep the disassembled parts in order and protect them from dust and dirt.
• Before removal, installation or disassembly, be sure to clarify the failure. Avoid unnecessary removal, in-
stallation, disassembly and replacement.
• Vehicle components are extremely hot after driving. Be wary of receiving burns from heated parts.
• Be sure to tighten fasteners including bolts and nuts to the specified torque.
• Place shop jacks or rigid racks at the specified points.
• Before disconnecting connectors of sensors or units, be sure to disconnect the ground cable from the bat-
tery.
• Place "NO FIRE" signs near the working area.
• Be careful not to spill fuel.
D: PREPARATION TOOL
ILLUSTRATION
ST42099AE000
General Description
(14) Canister
(15) Drain Valve
(16) Drain filter
(17) Canister protector
(18) Pressure control solenoid valve
(19) Evaporation pipe A
(20) Evaporation pipe B
(21) Clip
(22) Fuel filler pipe
(23) Shut valve
(24) Packing
(25) Ring
(26) Fuel filler cap
TOOL NUMBER DESCRIPTION
42099AE000 CONNECTOR
REMOVER
FU(H4SO)-9
FUEL INJECTION (FUEL SYSTEMS)
(27) Fuel tank pressure sensor
(28) Evaporation pipe protector
(29) Connector A
(30) Canister hose A
(31) Connector B
(32) Canister hose B
Tightening torque: N·m (kgf-m, ft-lb)
T1: 4.4 (0.45, 3.2)
T2: 7.5 (0.76, 5.5)
T3: 1.25 (0.13, 0.94)
T4: 17.6 (1.8, 13)
T5: 1.25 (0.13, 0.94)
REMARKS
Used for removing the quick connector.