Subaru LEGACY 2006 Manual page 21

asieps_tobira.book 2 ページ ２００９年１０月２６日 月曜日 午前９時１６分
PRECAUTION
1. Precaution
A: CAUTION
Please clearly understand and adhere to the follow-
ing general precautions. They must be strictly fol-
lowed to avoid minor or serious injury to the person
doing the work or people in the area.
1. ABS
Handle the ABS as a total system. Do not disas-
semble or attempt to repair parts which are not in-
structed in this manual. Follow the directions in this
manual when performing maintenance on the AB-
SCM&H/U When parts other than those specified
are disassembled, it is possible that the ABS sys-
tem will not operate when needed or cause it to op-
erate incorrectly and result in injury.
2. VEHICLE DYNAMICS CONTROL (VDC)
Handle the VDC as a total system. Do not disas-
semble or attempt to repair individual parts. Doing
so could prevent the VDC system from operating
when needed or cause it to operate incorrectly and
result in injury.
3. BRAKE FLUID
If brake fluid gets in your eyes or on your skin, do
the following:
• Wash eyes and seek immediate medical atten-
tion.
• Wash your skin with soap and then rinse thor-
oughly with water.
4. RADIATOR FAN
The radiator fan may rotate without warning, even
when the engine is not ON. Do not place your hand,
cloth, tools or other items near the fan at any time.
5. ROAD TEST
Always conduct road tests in accordance with traf-
fic rules and regulations to avoid bodily injury and
interrupting traffic.
6. AIRBAG
To prevent bodily injury from unexpected deploy-
ment of airbags and unnecessary maintenance, fol-
low the instructions in this manual when performing
maintenance on or near the airbag components,
around front of the vehicle (radiator panel, front
wheel apron, front side frame, front bumper, front
hood, front fender), around side of the vehicle (front
door, rear door, center pillar, rear fender, side sill,
rear wheel apron), and on or near the airbag wiring
harnesses.
To prevent unexpected deployment, turn the igni-
tion switch to OFF and disconnect the ground cable
from battery, then wait at least 20 seconds before
starting work.
Precaution
7. AIRBAG AND SEAT BELT PRETEN-
SIONER DISPOSAL
To prevent bodily injury from unexpected airbag
deployment, do not dispose the airbag modules
and seat belt pretensioner in the same way as oth-
er waste. Follow all government regulations con-
cerning disposal of refuse.
8. AIRBAG MODULE
Adhere to the following when handing and storing
the airbag module to prevent bodily injury from un-
expected deployment:
• Do not hold the harnesses or connectors to carry
the module.
• Do not face the bag in the direction that it opens
towards yourself or other people.
• Do not face the bag in the direction that it opens
towards the floor or walls.
9. AIRBAG SPECIAL TOOL
To prevent unexpected deployment, only use spe-
cial tools.
10.WINDOW
Always wear safety glasses when working around
any glass to prevent glass fragments from damag-
ing your eyes.
11.WINDOW ADHESIVE
Always use the recommended or equivalent adhe-
sive when attaching glass to prevent it from coming
falling, resulting in accidents and injury.
12.OIL
When handling oil, carefully observe the following
to prevent unexpected accidents.
• Prepare container and waste cloths when per-
forming work which oil could possibly spill. If oil
spills, wipe it off immediately to prevent from pene-
trating into floor or flowing outside, for environmen-
tal protection.
• Follow all government regulations concerning
disposal of refuse when disposing.
13.FUEL
When handling and storing fuel, carefully observe
the following to prevent unexpected accidents.
• Be careful of fires.
• Prepare a container and cloth to prevent scatter-
ing of fuels when performing work where fuels can
be spilled. If the fuel spills, wipe it off immediately to
prevent it from penetrating the floor or flowing out,
to protect the environment.
• Follow all government and local regulations con-
cerning disposal of refuse when disposing.
PC-2