Subaru LEGACY 2006 Manual page 307

asieps_tobira.book 270 ページ ２００９年１０月２６日 月曜日 午前９時１６分
Diagnostic Procedure with Diagnostic Trouble Code (DTC)
ENGINE (DIAGNOSTICS)
Step
1 CHECK OPERATION OF STARTER MOTOR.
• Place the inhibitor switch in "P" or "N" range.
(AT model)
• Depress the clutch pedal. (MT model)
• Check the security alarm is not sounding.
Check
Does the starter motor operate
when ignition switch is turned
to "ST"?
EN(H4SO)(diag)-270
Yes No
Repair the har- Check the starter
ness and connec- motor circuit. <Ref.
tor. to
EN(H4SO)(diag)-
NOTE:
56, STARTER
In this case, repair
MOTOR CIRCUIT,
the following item:
Diagnostics for
• Open or ground
Engine Starting
short circuit of har-
Failure.>
ness between
ECM and starter
motor connector
• Poor contact in
ECM connector