Subaru LEGACY 2006 Manual page 804

asieps_tobira.book 32 ページ ２００９年１０月２６日 月曜日 午前９時１６分
MECHANICAL
11) Install the power steering pump.
(1) Install the power steering pump to the brack-
et, and tighten the bolts.
Tightening torque:
22 N·m (2.2 kgf-m, 16 ft-lb)
(2) Connect the power steering switch connec-
tor.
(3) Install and adjust the front side belt. <Ref. to
ME(H4SO)-36, FRONT SIDE BELT, INSTAL-
LATION, V-belt.>
12) Lift-up the vehicle.
13) Tighten the bolts and nuts which hold lower
side of the transmission to engine.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
Engine Assembly
14) Tighten the nuts which install the front cushion
rubber onto crossmember.
Tightening torque:
75 N·m (7.6 kgf-m, 55.3 ft-lb)
NOTE:
Make sure the front cushion rubber mounting bolts
(A) and locator (B) are securely installed.
FU-00139
15) Connect the ground cable.
16) Install the front and center exhaust pipe.
<Ref. to EX(H4SO)-5, INSTALLATION, Front Ex-
haust Pipe.>
17) Lower the vehicle.
18) Connect the following hoses.
(1) Fuel delivery hose and evaporation hose
(2) Heater inlet and outlet hoses
(3) Brake booster vacuum hose
19) Connect the following connectors.
FU-00878
(1) Front oxygen (A/F) sensor connector
(2) Rear oxygen sensor connector
(3) Engine harness connectors
(4) Generator connector and terminal
(5) A/C compressor connector
20) Install the air intake chamber stay.
Tightening torque:
16 N·m (1.6 kgf-m, 11.6 ft-lb)
21) Tighten the engine ground cable.
Tightening torque:
14 N·m (1.4 kgf-m, 10.1 ft-lb)
22) Install the A/C pressure hoses.
<Ref. to AC-38, INSTALLATION, Hose and Tube.>
23) Install the radiator to vehicle. <Ref. to
CO(H4SO)-20, INSTALLATION, Radiator.>
24) Install the air intake duct, air cleaner case and
air intake chamber. <Ref. to IN(H4SO)-8, INSTAL-
LATION, Air Intake Duct.> <Ref. to IN(H4SO)-6,
ME-00219
INSTALLATION, Air Cleaner Case.> <Ref. to
IN(H4SO)-7, INSTALLATION, Air Intake Cham-
ber.>
25) Install the under cover.
26) Install the battery in the vehicle, and connect
cables.
ME(H4SO)-32
(B) (A) (A) (B)
ME-02651