Subaru LEGACY 2006 Manual page 325

asieps_tobira.book 288 ページ ２００９年１０月２６日 月曜日 午前９時１６分
Diagnostic Procedure with Diagnostic Trouble Code (DTC)
ENGINE (DIAGNOSTICS)
Step
13 CHECK SENSOR OUTPUT.
1) Connect all connectors.
2) Turn the ignition switch to ON.
3) Read the data of main throttle sensor signal
using Subaru Select Monitor.
NOTE:
Subaru Select Monitor
For detailed operation procedure, refer to
"READ CURRENT DATA FOR ENGINE". <Ref.
to EN(H4SO)(diag)-26, Subaru Select Moni-
tor.>
14 CHECK SENSOR OUTPUT.
Read the data of sub throttle sensor signal
using Subaru Select Monitor.
NOTE:
Subaru Select Monitor
For detailed operation procedure, refer to
"READ CURRENT DATA FOR ENGINE". <Ref.
to EN(H4SO)(diag)-26, Subaru Select Moni-
tor.>
15 CHECK POOR CONTACT.
Check poor contact in connector between
ECM and electronic throttle control.
16 CHECK HARNESS BETWEEN ECM AND
ELECTRONIC THROTTLE CONTROL.
1) Turn the ignition switch to OFF.
2) Disconnect the connectors from ECM.
3) Disconnect the connectors from electronic
throttle control.
4) Measure the resistance between ECM con-
nector and electronic throttle control connector.
Connector & terminal
(B134) No. 29 — (E57) No. 3:
(B134) No. 18 — (E57) No. 6:
(B134) No. 28 — (E57) No. 4:
17 CHECK HARNESS BETWEEN ECM AND
ELECTRONIC THROTTLE CONTROL.
1) Connect the ECM connector.
2) Measure the resistance between electronic
throttle control connector and engine ground.
Connector & terminal
(E57) No. 3 — Engine ground:
18 CHECK HARNESS BETWEEN ECM AND
ELECTRONIC THROTTLE CONTROL.
1) Turn the ignition switch to ON.
2) Measure the voltage between electronic
throttle control connector and engine ground.
Connector & terminal
(E57) No. 5 (+) — Engine ground (–):
19 CHECK HARNESS BETWEEN ECM AND
ELECTRONIC THROTTLE CONTROL.
Measure the voltage between electronic throt-
tle control connector and engine ground.
Connector & terminal
(E57) No. 6 (+) — Engine ground (–):
(E57) No. 4 (+) — Engine ground (–):
Check
Is the voltage less than 4.63
V?
Is the voltage less than 4.73
V?
Is there poor contact?
Is the resistance less than 1
Ω?
Is the resistance less than 5
Ω?
Is the voltage less than 10 V?
Is the voltage less than 10 V?
EN(H4SO)(diag)-288
Yes No
Go to step 14. Go to step 16.
Go to step 15. Go to step 16.
Repair the poor Go to step 21.
contact.
Go to step 17. Repair the open
circuit of harness
connector.
Go to step 18. Repair the poor
contact of ECM
connector.
Replace the ECM
if defective.
Go to step 19. Repair the battery
short circuit of har-
ness between
ECM connector
and electronic
throttle control
connector.
Go to step 20.
Repair the short
circuit of harness
between ECM
connector and
electronic throttle
control connector.