Subaru LEGACY 2006 Manual page 887

asieps_tobira.book 10 ページ ２００９年１０月２６日 月曜日 午前９時１６分
STARTING/CHARGING SYSTEMS
D: ASSEMBLY
1) Press-fit the rear bearing into end frame.
(1) Set an appropriate tool (φ22 mm) to rear
bearing.
(2) Press-fit the rear bearing using a press.
NOTE:
• Use a new bearing.
• Use a flat base.
• Press-fit the bearing outer ring until it contact to
the base bottom.
(A) BASE
2) Press-fit the oilless bearing into shock absorber
bearing.
(1) Set an appropriate tool (φ20 mm) to oilless
bearing.
(2) Press-fit the oilless bearing using a press.
NOTE:
• Use a new bearing.
• Use a flat base.
• Press-fit the bearing outer ring until it contact to
the base bottom.
(A)
(A) BASE
Starter
3) Press-fit the front bearing into front bracket.
(1) Set the front bearing into front bracket.
(2) Set an appropriate tool (2.0 mm thickness
plate) to front bracket, and press-fit the front
bearing using a press.
NOTE:
• Use a new bearing.
• Measure the protrusion of front bearing after
press-fitting, to check if it is within standard value.
Standard
2.0 — 2.4 mm (0.0787 — 0.0945 in)
(A)
SC-02058
(A) Front bearing
(B) PLATE
(C) Front bracket
4) Assemble the internal gear and wave washer to
shock absorber bearing.
NOTE:
Align with the pawl position of shock absorber bear-
ing to install internal gear.
(A) Shock absorber bearing
SC-02059
(B) Wave washer
(C) Internal gear
SC(H4SO)-10
(B)
(A)
(C)
SC-02060
(B)
(A)
(C)
SC-02061