Subaru LEGACY 2006 Manual page 398

asieps_tobira.book 5 ページ ２００９年１０月２６日 月曜日 午前９時１６分
3. General Description
A: CAUTION
1) Airbag system wiring harness is routed near the
ECM, main relay and fuel pump relay.
CAUTION:
• All airbag system wiring harnesses and con-
nectors are yellow. Do not use electrical test
equipment on these circuits.
• Be careful not to damage the airbag system
wiring harness when servicing the ECM, TCM,
main relay and fuel pump relay.
2) Never connect the battery in reverse polarity.
• The ECM will be destroyed instantly.
• The fuel injector and other parts will be dam-
aged.
3) Do not disconnect the battery terminals while the
engine is running.
A large counter electromotive force will be generat-
ed in the generator, and this voltage may damage
electronic parts such as ECM etc.
4) Before disconnecting the connectors of each
sensor and ECM, be sure to turn the ignition switch
to OFF. Perform the Clear Memory Mode after con-
necting the connectors.
5) Poor contact has been identified as a primary
cause of this problem. Measure the voltage or re-
sistance of individual sensor or all electrical control
modules using a tapered pin with a diameter of less
than 0.64 mm (0.025 in). Do not insert the pin more
than 5 mm (0.20 in) into the part.
6) Before removing the ECM from the located posi-
tion, disconnect two cables on battery.
Otherwise, the ECM may be damaged.
CAUTION:
When replacing the ECM, be careful not to use
the wrong spec. ECM to avoid any damage on
the fuel injection system.
7) Connectors of each sensor in the engine com-
partment and the harness connectors on the en-
gine side and body side are all designed to be
waterproof. Even if the connectors are waterproof,
take care not to allow water to get into them when
washing the vehicle, or when servicing the vehicle
in rainy weather.
General Description
8) Use ECM mounting stud bolts at the body side
grounding point when measuring voltage and resis-
tance inside the passenger compartment.
(A) Stud bolt
9) Use the engine ground terminal or engine as-
sembly for the grounding point to the body when
measuring the voltage and resistance in engine
compartment.
10) Use TCM mounting stud bolts at the body side
grounding point when measuring voltage and resis-
tance inside the passenger compartment.
(A) Stud bolt
11) Every MFI-related part is a precision part. Do
not drop them.
EN(H4SO)(diag)-5
ENGINE (DIAGNOSTICS)
(A)
EN-00001
FU-01090
(A)
EN-00154