Subaru LEGACY 2006 Manual page 101

asieps_tobira.book 5 ページ ２００９年１０月２６日 月曜日 午前９時１６分
4. Canister
A: REMOVAL
1) Disconnect the ground cable from the battery.
2) Lift-up the vehicle.
3) Remove the rear wheel LH.
4) Remove the rear mud guard LH.
5) Disconnect quick connector (A).
6) Disconnect the drain valve connector (B).
7) Remove clip (C).
(A)
(A)
8) Remove the canister from body.
Canister
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)
IN-00203
(B)
(C)
EC-02079
EC-02080
EC(H4SO)-5
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
Check that there is no damage or dust on the quick
connector. If necessary, clean the seal surface of
the pipe.
Tightening torque:
8 N·m (0.8 kgf-m, 5.9 ft-lb)
C: INSPECTION
Make sure the canister and canister hoses are not
cracked or loose.
EC-02080