Subaru LEGACY 2006 Manual page 801

asieps_tobira.book 29 ページ ２００９年１０月２６日 月曜日 午前９時１６分
(6) A/C compressor connector
(7) Power steering switch connector
13) Disconnect the following hoses.
(1) Brake booster vacuum hose
(2) Heater inlet and outlet hoses
14) Remove the power steering pump.
(1) Remove the front side V-belts. <Ref. to
ME(H4SO)-36, FRONT SIDE BELT, REMOV-
AL, V-belt.>
(2) Remove the bolts which secure the power
steering pump to the bracket.
Engine Assembly
(3) Place the power steering pump on the right
side wheel apron.
15) Remove the front and center exhaust pipes.
<Ref. to EX(H4SO)-4, REMOVAL, Front Exhaust
Pipe.>
16) Disconnect the ground cable.
17) Remove the bolts and nuts which hold lower
side of transmission to engine.
ME-00819
18) Remove the nuts which install front cushion
rubber onto front crossmember.
FU-00878
19) Separate the torque converter clutch from drive
plate. (AT model)
(1) Lower the vehicle.
(2) Remove the service hole plug.
ME-02698
(3) Remove the bolts which hold torque con-
verter clutch to drive plate.
(4) Remove other bolts while rotating the en-
gine using a socket wrench.
FU-00139
ME(H4SO)-29
MECHANICAL
ME-00210
ME-02650
ME-00212