Subaru LEGACY 2006 Manual page 42

asieps_tobira.book 4 ページ ２００９年１０月２６日 月曜日 午前９時１６分
PRE-DELIVERY INSPECTION
PROCEDURE
24. Seat
25. Seat belt
CHECKS WITH ENGINE RUNNING
PROCEDURE
26. Test mode connector
27. Immobilizer system
28. Starting condition
29. Exhaust system
30. Indicator and warning lights
31. Clock
32. Audio
33. Navigation system
34. Front accessory power supply socket
35. Lighting system
36. Wiper deicer
37. Illumination control
38. Window washer
39. Wiper
40. Power window operation check
41. Sunroof
42. Door mirror
DYNAMIC TEST WITH THE VEHICLE RUNNING
PROCEDURE
43. Brake test
44. Parking brake
45. AT shift control
46. Heater and ventilation
47. Air conditioner
48. Cruise control
CHECKS AFTER DYNAMIC TEST
PROCEDURE
49. ATF level
50. Power steering fluid level
51. Fluid leak check
52. Water leak test
53. Appearance check 2
Pre-delivery Inspection
1. Check the seat surfaces for stains or dirt.
2. Check the seat installation conditions and functionality.
3. Check that the occupant detection system for passenger's seat operates
normally.
1. Check the seat belt installation conditions and functionality.
2. Check that the seat belt warning system operates normally.
Test mode connector
1. Check that the engine starts with all keys that are equipped on vehicle.
2. 60 seconds after turning ignition switch from ON to ACC or OFF, or imme-
diately after removing the key, check that the security indicator light blinking.
Start the engine and check that the engine starts smoothly.
Check that the exhaust noise is normal and no leaks are found.
Check that all the indicator and warning lights are gone out.
Check that the clock operates normally.
Check the radio, CD player for normal operation.
1. Check all display functions for normal operation.
2. Check the map disc (DVD) are provided on vehicle.
3. Check that the navigation system operates normally.
Check that the front accessory power socket operates normally.
Check that the lighting system operates normally.
Check that the wiper deicer operates normally.
Check that the illumination control operates normally.
Check that the window washer system operates normally.
Check that the wiper system operates normally.
Check that the power window operations normally.
Check that the sunroof operates normally.
Check that the remote control mirror operates normally.
Check the foot brake for normal operations.
Check the parking brake for normal operations.
Check that the AT shift patterns are correct.
Check that the heater and ventilation system operates normally.
Check that the air conditioner operates normally.
Check that the cruise control system operates normally.
Check that the ATF level is correct.
Check that the power steering fluid level is normal.
Check for fluid/oil leaks.
Spray the vehicle with water and check for water leaks.
1. Remove the protective coating (if equipped).
2. Check the body paints for damage and stain.
3. Check the plated parts for damage and rust.
PI-4
Check point
Check point
Check point
Check point