Subaru LEGACY 2006 Manual page 937

asieps_tobira.book 32 ページ ２００９年１０月２６日 月曜日 午前９時１６分
ENGINE (DIAGNOSTICS)
6. READ FREEZE FRAME DATA FOR ENGINE (OBD MODE)
1) On the «Main Menu» display screen, select the {Each System Check} and press the [YES] key.
2) On the «System Selection Menu» display screen, select the {Engine Control System} and press the [YES]
key.
3) Press the [YES] key after the information of engine type has been displayed.
4) On the «Engine Diagnosis» display screen, select the {OBD System} and press the [YES] key.
5) On the »OBD Menu» display screen, select the {Freeze Frame Data} and press the [YES] key.
A list of the support data is shown in the following table.
DTC of freeze frame data
Air fuel ratio control system for bank 1
Engine load data
Engine coolant temperature signal
Short term fuel trim by front oxygen (A/F) sensor
Long term fuel trim by front oxygen (A/F) sensor
Intake manifold absolute pressure signal
Engine speed signal
Vehicle speed signal
Ignition timing signal
Intake air amount
Intake air temperature signal
Throttle position signal
Oxygen sensor (Bank 1 Sensor 2)
A/F correction (Bank 1 Sensor 2)
Front oxygen (A/F) sensor (Bank 1 Sensor 1)
Oxygen sensor (Bank 1 Sensor 2)
NOTE:
For detailed operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL".
Subaru Select Monitor
Contents
EN(H4SO U5)(diag)-32
Display
Freeze frame data
Fuel system for Bank1
Engine Load
Coolant Temp.
Short term fuel trim B1
Long term fuel trim B1
Mani.Absolute Pressure mmHg, kPa, inHg or psig
Engine Speed
Vehicle Speed
Ignition Timing
Mass Air Flow
Intake Air Temp.
Throttle Opening Angle
Oxygen sensor #12
Short term fuel trim #11
Oxygen sensor #11
Oxygen sensor #12
Unit of measure
DTC
Normal CLOSE or initial
OPEN
%
°C or °F
%
%
rpm
km/h or MPH
°
g/s or lb/m
°C
%
V
%
Support
Support