Subaru LEGACY 2006 Manual page 773

asieps_tobira.book 37 ページ ２００９年１０月２６日 月曜日 午前９時１６分
2. REAR SIDE BELT
1) Install the belt tensioner.
2) Install a V belt, and tighten the slider bolt (B) so
as to obtain the specified belt tension.
<Ref. to ME(H4SO)-37, INSPECTION, V-belt.>
3) Tighten the lock nut (A).
Tightening torque:
Lock nut (A)
23 N·m (2.3 kgf-m, 17.0 ft-lb)
(B)
C: INSPECTION
1) Replace the belts, if crack, fraying or wear is
found.
2) Remove the V-belt cover and reservoir tank.
(with belt tension gauge)
3) Check the V-belt tension and adjust it if neces-
sary by changing the generator installing position
or idler pulley installing position.
Belt tension (with belt tension gauge):
(A)
When installing new parts:
618 — 755 N (63 — 77 kgf, 139 — 170 lb)
At inspection
490—640 N (50.0—65.3 kgf, 110.2—143.9
lb)
(B)
When installing new parts:
740—880 N (75.5—89.7 kgf, 166—198 lb)
At inspection
350 — 450 N (35.7 — 45.9 kgf, 78.7 — 101.2
lb)
V-belt
GEN Generator
(A)
Belt tension (without belt tension gauge):
ME-00224
(A)
When installing new parts:
7 — 9 mm (0.276 — 0.354 in)
At inspection
9 — 11 mm (0.354 — 0.433 in)
(B)
When installing new parts:
7.5 — 8.5 mm (0.295 — 0.335 in)
At inspection
9.0 — 10.0 mm (0.354 — 0.394 in)
GEN Generator
ME(H4SO)-37
(A)
GEN
P/S
C/P
(A) Front side belt
(B) Rear side belt
C/P Crank pulley
P/S Power steering oil pump pulley
A/C Air conditioning compressor pulley
I/P Idler pulley
98 N (10 kg, 22 Ib)
GEN
P/S (A) (B)
C/P
(A) Front side belt
(B) Rear side belt
C/P Crank pulley
P/S Power steering oil pump pulley
A/C Air conditioning compressor pulley
I/P Idler pulley
MECHANICAL
A/C
(B)
I/P
PM-00154
A/C
I/P
ME-00226