Subaru LEGACY 2006 Manual page 936

asieps_tobira.book 31 ページ ２００９年１０月２６日 月曜日 午前９時１６分
5. READ CURRENT DATA FOR ENGINE (OBD MODE)
1) On the «Main Menu» display screen, select the {Each System Check} and press the [YES] key.
2) On the «System Selection Menu» display screen, select the {Engine Control System} and press the [YES]
key.
3) Press the [YES] key after the information of engine type has been displayed.
4) On the «Engine Diagnosis» display screen, select the {OBD System} and press the [YES] key.
5) On the «OBD Menu» display screen, select the {Current Data Display/Save}, and then press the [YES]
key.
6) On the «Data Display Menu» screen, select the {Data Display} and press the [YES] key.
7) Using the scroll key, scroll the display screen up or down until the desired data is shown.
A list of the support data is shown in the following table.
Description
Number of diagnosis code
Condition of malfunction indicator light
Misfire monitoring
Fuel system monitoring
Component monitoring
Test of catalyst
Test of heating-type catalyst
Test of evaporative purge system
Test of secondary air system
Test of A/C system refrigerant
Test of oxygen sensor
Test of oxygen sensor heater
Test of EGR system
A/F control #1
Load
Engine coolant temperature signal
A/F correction value #1
A/F learning value #1
Intake manifold absolute pressure
Engine speed signal
Vehicle speed signal
Ignition timing #1
Intake air temperature signal
Intake air amount
Throttle opening angle signal
Oxygen sensor (Bank 1 Sensor 2)
A/F correction (Bank 1 Sensor 2)
OBD system
Front oxygen (A/F) sensor (Bank 1 Sensor 1)
Oxygen sensor (Bank 1 Sensor 2)
Front oxygen (A/F) sensor (Bank 1 Sensor 1)
Front oxygen (A/F) sensor (Bank 1 Sensor 1)
Front oxygen (A/F) sensor (Bank 1 Sensor 1)
Front oxygen (A/F) sensor (Bank 1 Sensor 1)
NOTE:
For detailed operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL".
Subaru Select Monitor
Display
Number of DTC
MI (MIL)
Misfire monitoring
Fuel system monitoring
Component monitoring
Catalyst Diagnosis
Heated catalyst
Evaporative purge sys-
tem
Secondary air system
A/C system refrigerant
Oxygen sensor
O2 Heater Diagnosis
EGR system
Fuel system for BANK 1
Calculated load valve
Coolant Temp.
A/F Correction Value #1
A/F Learning Value #1
Mani. Absolute Pressure
Engine Speed
Vehicle Speed
Ignition timing adv.#1
Intake Air Temp.
Mass Air Flow
Throttle Opening Angle
Oxygen sensor #12
A/F Correction #12
OBD system
Oxygen sensor #11
Oxygen sensor #12
A/F sensor #11
A/F sensor #11
A/F sensor #11
A/F sensor #11
EN(H4SO U5)(diag)-31
ENGINE (DIAGNOSTICS)
Unit of measure Note (at idling)
— 0
— OFF
— Complete
— Complete
— Complete
— Incomplete
— No
— Incomplete
— No
— No
— Incomplete
— Complete
— Incomplete
— Normal CLOSE
% 23.0%
°C or °F +92°C
% –0.8%
% +0.0%
mmHg, kPa, 211 mmHg, 28.1 kPa,
inHg or psig 8.31 inHg or 4.08 psig
rpm 700 rpm
km/h or MPH 0 km/h or 0 MPH
° +16.0°
°C or °F 36°C or 97°F
g/s or lb/m 2.7 g/s or 0.36 lb/m
% 13%
V 0.7 V
% +0.0%
— CARB–OBD2
— Support
— Support
— 1.001
V 2.79 V
— 1.001
mA 0.00 mA