Subaru LEGACY 2006 Manual page 51

asieps_tobira.book 13 ページ ２００９年１０月２６日 月曜日 午前９時１６分
26.TEST MODE CONNECTOR
Turn the ignition switch to ON and check that the
malfunction indicator light starts blinking. If the light
blinks, return the ignition key to LOCK. Pull out the
test mode connector from the back of glove box
lower cover, and disconnect the test mode connec-
tor. Then, turn the ignition key to ON again. If the
malfunction indicator light blinks at that time in spite
of the disconnected test mode connector, carry out
an engine diagnosis.
(A) Test mode connector (green)
27.IMMOBILIZER SYSTEM
1) Check that the engine starts with all keys that
are equipped on vehicle.
2) 60 seconds after turning ignition switch from ON
to ACC or OFF, or immediately after removing the
key, check that the security indicator light blinking.
NOTE:
If malfunctions occur, refer to "IMMOBILIZER (DI-
AGNOSIS)".
28.STARTING CONDITION
Start the engine and check that the engine starts
smoothly. If the battery voltage is low, recharge or
replace the battery. If any noises are observed, im-
mediately stop the engine and check and repair the
abnormal components.
29.EXHAUST SYSTEM
Listen to the exhaust noise to see if no noises are
observed. Check for exhaust leaks.
30.INDICATOR AND WARNING LIGHTS
Check that all the indicator and warning lights are
off.
31.CLOCK
Check the clock for normal operations and enough
accuracy.
32.AUDIO
Check the radio for full functionality and normal
noise level. Check the CD unit operations.
Pre-delivery Inspection
(A)
PI-00201
PI-13
PRE-DELIVERY INSPECTION
33.NAVIGATION SYSTEM
1) Check all display functions for normal operation.
2) Check the map disc (DVD) are provided on vehi-
cle.
3) Check that the navigation system operates nor-
mally.
34.FRONT ACCESSORY POWER SUPPLY
SOCKET
1) Check the operation of the front accessory pow-
er socket.
2) Check operation of the accessory power socket
in console box.
35.LIGHTING SYSTEM
1) Check the headlight operations.
2) Check the stop light operation.
3) Check other lights for normal operations.
36.WIPER DEICER
Check that the wiper deicer operates normally.
37.ILLUMINATION CONTROL
Check that the illumination control operates nor-
mally.