Subaru LEGACY 2006 Manual page 677

asieps_tobira.book 53 ページ ２００９年１０月２６日 月曜日 午前９時１６分
26.Fuel Sub Level Sensor
A: REMOVAL
WARNING:
• Place "NO FIRE" signs near the working area.
• Be careful not to spill fuel.
1) Drain fuel. <Ref. to FU(H4SO)-40, DRAINING
FUEL, PROCEDURE, Fuel.>
2) Remove the rear seat.
3) Remove the service hole cover.
(1) Remove bolt (A).
(2) Push the grommet (B) down and remove the
service hole cover.
(A)
4) Disconnect the connector from the fuel sub level
sensor.
5) Disconnect the quick connector, then disconnect
the fuel delivery hose and jet pump hose. <Ref. to
FU(H4SO)-56, REMOVAL, Fuel Delivery and
Evaporation Lines.>
Fuel Sub Level Sensor
6) Remove the nuts and bolts which install fuel sub
level sensor on fuel tank.
(A)
7) Remove the fuel sub level sensor.
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
• Use a new gasket.
• Make sure the sealing portion is free from fuel or
(B)
FU-01126
foreign matter before installation.
• Align protrusion (A) of the gasket to the position
shown in the follwing figure.
• Align protrusion (B) of the fuel sub level sensor to
the cut out in the fuel sublevel sensor upper plate.
• Tighten the bolts in the sequence shown in the
figure, to the specified torque.
Tightening torque:
FU-02672
FU(H4SO)-53
FUEL INJECTION (FUEL SYSTEMS)
(A)
(A) Jet pump hose
(B) Delivery hose
4.4 N·m (0.45 kgf-m, 3.2 ft-lb)
3
5
2
4
(A)
(B)
FU-02673
1
6
(B)
FU-02836
FU-02674