Subaru LEGACY 2006 Manual page 445

asieps_tobira.book 8 ページ ２００９年１０月２６日 月曜日 午前９時１６分
Diagnostic Trouble Code (DTC) Detecting Criteria
GENERAL DESCRIPTION
2. Diagnostic Trouble Code (DTC) Detecting Criteria
A: DTC P0026 INTAKE VALVE CONTROL SOLENOID CIRCUIT RANGE/PER-
FORMANCE (BANK 1)
1. OUTLINE OF DIAGNOSIS
Detect NG when having either Low NG or High NG.
A variable valve lift diagnosis oil pressure switch is installed for diagnosis. It is possible to determine whether
the intake valve is in high mode (increase the amount of lift) or in low mode (suppressing the amount of lift)
when the variable valve lift diagnosis oil pressure switch is turned OFF or ON.
• Normal
Oil switching solenoid valve duty
Large
Minimum
• Low NG
When the variable valve lift diagnosis oil pressure switch remains ON even though the intake valve tried to
enter high mode (oil switching solenoid valve duty is large), this is judged as a Low NG.
• High NG
When the variable valve lift diagnosis oil pressure switch remains OFF even though the intake valve tried to
enter low mode (oil switching solenoid valve duty is small), this is judged as a High NG.
2. COMPONENT DESCRIPTION
The variable valve lift system optimizes the intake valve lift by switching between the low lift cam and the high
lift cam according to the engine speed. The amount of intake valve lift is varied by controlling the oil switching
solenoid valve duty according to signals from the ECM.
3. ENABLE CONDITION
Secondary Parameters
Battery voltage
After engine starting
Engine oil temperature
Variable valve lift control
4. GENERAL DRIVING CYCLE
Perform the diagnosis continuously 6 seconds after engine start while variable valve lift is being controlled.
Variable valve lift diag-
Intake valve nosis oil pressure
switch
High mode OFF
Low mode ON
Enable Conditions
≥ 10.9 V
≥ 6 sec.
≥ 15°C (59°F)
Operating
GD(H4SO)-8