Subaru LEGACY 2006 Manual page 389

asieps_tobira.book 27 ページ ２００９年１０月２６日 月曜日 午前９時１６分
4. READ CURRENT DATA FOR ENGINE (NORMAL MODE)
1) On the «Main Menu» display screen, select the {Each System Check} and press the [YES] key.
2) On the «System Selection Menu» display screen, select the {Engine Control System} and press the [YES]
key.
3) Press the [YES] key after the information of engine type has been displayed.
4) On the «Engine Diagnosis» display screen, select the {Current Data Display/Save}, and then press the
[YES] key.
5) On the «Data Display Menu» screen, select the {Data Display} and press the [YES] key.
6) Using the scroll key, scroll the display screen up or down until the desired data is shown.
A list of the support data is shown in the following table.
Remarks
Engine load
Engine coolant temperature signal
A/F correction 1
A/F learning 1
Intake manifold absolute pressure
Engine speed signal
Meter vehicle speed signal
Ignition timing signal
Intake air temperature signal
Amount of intake air
Throttle opening angle signal
Rear oxygen sensor voltage
Battery voltage
Mass air flow voltage
Injection 1 pulse width
Knock sensor correction
Atmospheric pressure signal
Intake manifold relative pressure
Fuel tank pressure signal
Acceleration opening angle signal
Fuel temperature signal
Fuel level signal
Purge control solenoid duty ratio
EGR steps
A/F sensor current value 1
A/F sensor resistance value 1
A/F sensor output lambda 1
A/F correction 3
A/F learning 3
Throttle motor duty
Throttle power supply voltage
Sub throttle sensor voltage
Main throttle sensor voltage
Sub acceleration sensor voltage
Main acceleration sensor voltage
Memory vehicle speed
Fuel level sensor signal
Subaru Select Monitor
Display
Engine Load
Coolant Temp.
A/F Correction #1
A/F Learning #1
Mani. Absolute Pressure
Engine speed
Vehicle Speed
Ignition Timing
Intake Air Temp.
Mass Air Flow
Throttle Opening Angle
Rear O2 Sensor
Battery Voltage
Air Flow Sensor Voltage
Fuel Injection #1 Pulse
Knocking Correction
Atmosphere Pressure
Mani. Relative Pressure
Fuel Tank Pressure
Accel. Opening Angle
Fuel Temp.
Fuel Level
CPC Valve Duty Ratio
No. of EGR Steps
A/F Sensor #1 Current
A/F Sensor #1 Resistance
A/F sensor output lambda 1
A/F Correction #3
A/F Learning #3
Throttle Motor Duty
Throttle Motor Voltage
Sub-throttle Sensor
Main-throttle Sensor
Sub-accelerator Sensor
Main-accelerator Sensor
Memorized Cruise Speed
Fuel level resistance
EN(H4SO)(diag)-27
ENGINE (DIAGNOSTICS)
Unit of measure Note (at idling)
% 21.0%
°C or °F 94°C or 201°F
% –0.8%
% 0.0%
200 — 300 mmHg, 26.7 —
mmHg, kPa,
40 kPa, 7.8 — 11.8 inHg or
inHg or psig
3.8 — 5.8 psig
700 rpm (Agree with the
rpm
tachometer indication)
km/h or MPH 0 km/h or 0 MPH (at parking)
deg 14 — 16 deg
°C or °F (Ambient air temperature)
g/s or lb/m 2.5 g/s or 0.33 lb/m
% 2.0%
V 0.1 — 0.7 V
V 12 — 14 V
V 1.26 V
ms 2.82 ms
deg 0.0 deg
mmHg, kPa,
(Atmosphere pressure)
inHg or psig
mmHg, kPa, (Air intake absolute pressure
inHg or psig – atmosphere pressure)
mmHg, kPa, +7.9 mmHg, +1.1 kPa, +0.31
inHg or psig inHg or +0.15 psig
% 0.0%
°C or °F +20°C or +68°F
V 0 — 5 V
% 0 — 3%
STEP 0 STEP
mA –0.2 — 0.2 mA
Ω 32 Ω
— 1.0
% 0.3%
% 0.00%
% –15%
V (Battery voltage)
V 1.52 V
V 0.66 V
V 0.68 V
V 0.68 V
km/h or MPH 0 km/h or 0 MPH
Ω 69.6 Ω